Drip irrigation installation process

There are many methods through which to assure the water needs of your plants. The drip irrigation system is the most efficient of all because it delivers water directly to the roots of the plant, thus preventing water from getting to weeds and avoiding water loss almost entirely. The drip irrigation system is suitable for most plants and trees.

Determine the water flow rate per hour of the outdoor water source, by counting the time it takes to fill up a bucket and dividing that time to the number of gallons the bucket has then multiplying the result by 3,600.

You must connect a few devices to the main hose. Start by connecting the back flow preventer, than the controller, water filter and pressure regulator. Follow the instructions given on the system kit.

Next up, connect the drip tube to the rest of the system. Turn the cold water on and wait for the tube to shrink. When it stops, turn the water off. Close the tubing with an 8-figure clamp.

Place the tubing across the garden avoiding any sharp angles and kinks if you aren’t using any right-angle or T-connectors. Make sure the tubing passes over the roots areas that need irrigation.

Use a puncher to make holes in the drip tube and then place emitters at the base of each plant. The emitters must be simply secured into the holes through insertion. If you puncture a hole in a wrong area, plug it with a goof plug.

Make sure you sum the flow rates of the emitters. The quantity of water needed per hour mustn’t be more than the flow rate calculated at the earlier. Here is a helping equivalent: installing two 1/2-gallon-per-hour emitters, four 1-gallon-per-hour emitters and one 2-gallon-per-hour emitter means that the system requires 7 gallons of water per hour.

Cover up the tubing and emitters with mulch. Any exposed area of tubing should be secured with wire anchors. Clean the irrigation system by flushing it and using chlorine solution to avoid buildups and clogging. Inspect the system regularly to assure it works properly.

drip irrigation, drip irrigation backflow preventer, drip irrigation components, drip irrigation efficiency, drip irrigation installation, drip irrigation installation process, drip irrigation parts, drip irrigation position, drip irrigation pressure regulator, drip irrigation system, drip irrigation water faucet, drip irrigation water filter, drip irrigation water spigot, garden drip system, garden irrigation system, irrigation, irrigation system